Washing Machine Service

If your machine doesn't turn on, it could be a tripped circuit, faulty door lock switch, or damaged control board. We diagnose the wiring and replace faulty parts to get it running again.

A drum that won't spin is usually caused by a worn drive belt, faulty motor, or broken lid switch. Our technicians inspect the motor assembly and belt system to restore full spin power.

Leaks often come from a cracked hose, worn door gasket, or loose drain pipe connection. We trace the leak source and replace damaged seals or hoses to keep your floor dry.

Loud banging or shaking is typically due to unbalanced loads, worn shock absorbers, or loose drum bearings. We rebalance, tighten, and replace worn suspension parts for smooth, quiet cycles.

Water left in the drum after a cycle points to a clogged drain pump, blocked hose, or faulty drain filter. We clear blockages and repair the pump so water drains fully every time.

A faulty door latch or lock mechanism can stop a cycle from starting or finishing. We replace worn latches and sensors so the door locks securely and opens smoothly when the cycle ends.

A musty smell is often caused by detergent buildup, mold in the gasket, or a clogged drain filter. We deep clean the drum, gasket, and filter to leave your machine fresh and odor-free.

Error codes usually point to sensor faults, water inlet issues, or control board glitches. Our technicians read the diagnostic code and fix the exact part causing the fault.

Correct installation prevents leaks, vibration, and drainage problems later. We provide complete setup including water inlet, drainage, leveling, and electrical connection for all major brands.